Fir Configuration File

#
#                     Configuration File for Fir
#
MyModId          MOD_FIR
InRing           WAVE_RING       # Transport ring to find waveform data on,
OutRing          WAVE_RING       # Transport ring to write output to,
                                 # InRing and OutRing may be the same.
HeartBeatInterval     30         # Heartbeat interval, in seconds,
LogFile            1             # 1 -> Keep log, 0 -> no log file
#Debug		 		 # Write out debug messages (optional)

MaxGap              1.5         # Maximum gap, in sample periods, allowed
                                # between trace data points.
                                # When exceeded, channel is restarted.

# Specify the filter frequency response characteristics with two or more
# commands fo the form: Band    
#
# where:
#   f_low = low frequency limit of a band
#   f_high = high frequency limit of a band
#   level = desired level of the band: 1 for pass band, 0 for stop band
#   deviation = amount of ripple allowed from desired level
#
# All frequencies specified must be in the range 0.0 - 1.0, where 1.0
# corresponds to the Nyquist frequency. (Nyquist frequency is half the sample
# rate and is the maximum frequency content that can be in a time series.)
# One band must start at 0.0 frequency; one band must end at 1.0 frequency. Any
# number of additional bands may be specified (up to a total of ten bands.)
Band 0.0 0.3 1 0.005
Band 0.4 1.0 0 0.005

# If you want Fir to compute and log its filter coefficients and then
# exit, specify "TestMode".
#TestMode

# NEW OPTIONAL SETTINGS FOR Earthworm release 7.5
# optional setting to allow a queue buffer size larger than 100 messages, defaults to 100
QueueSize 2000
# optional setting to allow a shorter sleep between ring pollings, defaults to 500
SleepMilliSeconds 50

 #
# Specify logos of the messages to grab from the InRing.
# TYPE_TRACEBUF is assumed, therefore only module ID and
# installation ID need to be specified
#
GetWavesFrom    INST_WILDCARD MOD_WILDCARD  # TYPE_TRACEBUF (assumed)

#
# List SCNL codes of trace messages to fir and their output SCNL codes
# Wildcard characters are not allowed here.
#
#        IN-SCNL     OUT-SCNL
GetSCNL TEST EHZ UW --  TEST EWZ UW --